Pelton Turbine HM 450.01
The Pelton turbine is a type of free-jet resp. impulse turbine which convert the pressure energy of water into kinetic energy entirely in the distributor. Pelton turbines are used at large heads and relatively low flow rates. The turbine power is adjusted by means of the nozzle cross-section. In practice, Pelton turbines are used for driving synchronous generators, where they run at constant speed.
The Pelton turbine HM 450.01 is an accessory for the HM 450C trainer. The experimental unit consists of the Pelton wheel, a needle nozzle used as distributor, a band brake for loading the turbine and a housing with a transparent front panel. The transparent cover enables you to observe the water flow, the Pelton wheel and the nozzle during operation. You can change the nozzle cross-section and thus the flow rate by adjusting the nozzle needle.
The pressure at the turbine inlet is recorded with a pressure sensor. A force sensor and a speed sensor are attached to the band brake. Thus, the mechanical power output of the turbine can be determined. Speed, torque and pressure are displayed on the switch cabinet of HM 450C and processed further in the software. Water supply and flow rate measurement are provided by HM 450C.
The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.
- determination of mechanical output
- determination of efficiency
- recording of characteristic curves
- investigation of the influence of the nozzle cross-
section on the power output
* Pelton turbine with visible operating area1
* Closed water circuit and data processing software
for use with the HM 450C trainer
HM 289 -- Experiments with a Pelton Turbine
HM 365.31 -- Pelton and Francis Turbine
 recording the curves of a Pelton turbine and investigating the influence of the nozzle cross-section
 transparent front panel for observing the operating area
 loading the turbine by use of a band brake
 adjustable nozzle needle for setting different nozzle cross-sections
 non-contact speed measurement at the turbine shaft and force sensor at the brake for measuring the torque
 force sensor at the turbine inlet
 speed, torque and pressure displayed on the switch cabinet of HM 450C
 water supply, flow rate measurement and data processing software via HM 450C
- output: approx. 350W at 1000min-1, 150L/min,
- max. speed: 1500min-1
- Pelton wheel
medium diameter: 165mm
- torque: 0...9,81Nm
- pressure: 0...4bar abs.
- speed: 0...4000min-1
Weight: approx. 27kg Scope of Delivery 1 experimental unit
1 set of instructional material Order Details 070.45001 HM 450.01 Pelton Turbine