Cutting Forces during Turning FT 102

Cutting Forces during Turning

Type: FT 102
Name: Cutting Forces during Turning
Categorie:
Technical Description

  Investigation of cutting forces during turning is fundamental to the teaching of cutting techniques.The setup comprises a transducer, which also holds the lathe tool, and an amplifier unit with digital displays. The forces that act on the lathe tool during machining are measured in three directions: cutting force, feed force and passive force. The 3-component force measurement device uses a strain gauge system. The amplifier unit supplies the strain gauge bridges and displays the measured values on three digital displays.
  The experiments must be conducted in a workshop environment, as a suitable lathe is required.
  The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.

 

Learning Objectives / Experiments

- measurement of forces in turning
  * influence of rotational speed, rate of feed, feed motion, lubrication 
     and cooling conditions
- influence of the cutting geometry of the lathe tool
- influence of the material being machined

 

Features
* Measurement of the forces acting on the lathe tool
Available accessories
WP 300.09 -- Laboratory Trolley
Alternative products
FT 100 -- Cutting Forces during Drilling
Specification

[1] 3-component force measuring device for cutting experiments during turning
[2] lathe tool holder implemented as transducer with strain gauge system
[3] strain gauge amplifier unit with 3 digital displays for forces
[4] transducer with splash-proof housing
[5] GUNT software for data acquisition via USB under Windows Vista or Windows 7

 

Technical Data

Force sensor
- number of force axes: 3 (x, y, z)
- measuring range: +/-5kN
- overload capacity up to: +/- 6,5kN
- breaking load: +/-8kN
- non-linearity: <1%
- supply: 10VDC
Strain gauge in full-bridge configuration

 

Dimensions and Weight LxWxH: 365x315x150mm (measuring amplifier)
Weight: approx. 7kg Required for Operation 230V, 50/60Hz, 1 phase or 120V, 60Hz/CSA, 1 phase Scope of Delivery

1 measuring device for turning experiments, comprising strain gauge

   amplifier and transducer

1 GUNT software CD + USB cable
1 set of instructional material

Order Details 054.10200  FT 102  Cutting Forces during Turning

Documentatie

Foto's