Fuel cell system ET 292

Fuel cell system

Type: ET 292
Name: Fuel cell system


Fuel cells are energy converters that, unlike heat engines, convert chemical energy directly into electrical energy. Heat is generated as a by-product during this process.

The main component of ET 292 is a polymer-membrane fuel cell which is operated in combined heat and power generation. The system is supplied with high-purity hydrogen from a pressure vessel on the anode side and with oxygen from the ambient air on the cathode side. The fuel cell is operated either current-regulated or voltage-regulated via an integrated electronic load. The setpoint of the electronic load allows a precise adjustment of all operating points and a very accurate recording of characteristics. The technically usable thermal energy is dissipated to the environment via a cooling circuit and can be accounted for via the integrated instrumentation. The water accruing during operation is collected in a water separator. In the fuel cell’s dead-end mode the accruing water is disposed of via a configurable purge valve for hydrogen. The system is operated via a PC.

Auxiliary energy for pump, fan and control required for operation is provided from the mains. The moisture in the stack can be regulated via adjustement of the purge valve, so that no external humidification is required. All relevant measuring values are recorded to work out the fuel cell’s energy balance. The measured values are transmitted directly to a PC via USB. The GUNT data acquisition software is included.

Technical details

  • investigation of a polymer-membrane fuel cell
  • water cooled system in combined heat and power
  • hydrogen supplied via standard pressure vessel
  • high-pressure reducing valve for hydrogen pressure vessel supplied
  • oxygen supplies directly from the ambient air
  • precise adjustment of all operating points via electronic load
  • operation without external humidification
  • sensors for flow rate, pressure, temperature, voltage and current strength
  • complete operation and evaluation via a PC
  • GUNT software with control functions and data acquisition via USB under Windows 7, 8.1, 10
  • Technical data

    Nominal output: 300W
    Thermal power: approx. 400…500W depending on ambient conditions
    Required ambient temperature: 5…35°C
    Required inlet pressure: 2…200bar

    Measuring ranges
    • flow rate:
      • 0…0,5L/min (cooling water)
      • 0…20sL/min (hydrogen)
      • 0…100sL/min (air)
    • pressure: 0…500mbar (hydrogen)
    • temperature:
      • 0…50°C (ambient)
      • 0…70°C (stack)
    • humidity: 0…100% (ambient)
    • voltage: 0…40V (stack)
    • current: 0,1…20A (stack)

    230V, 50Hz, 1 phase
    230V, 60Hz, 1 phase
    120V, 60Hz, 1 phase
    UL/CSA optional

    Dimensions and weight

    LxWxH: 1750x780x1770mm
    Weight: approx. 180kg

    Required for operation

    Hydrogen of purity 3.0 in pressure vessel
    PC with Windows